English
Leave Your Message
CNPC Lubricant Oil L-DAB Air Compressor Oil Kunlun Factory
Vacuum pump oil
Products Categories
Featured Products

KunLun 801 Electric Power Grease - 100 g Tube

KunLun 801 electric power grease is an NLGI 2 conductive contact grease supplied in a 100 g tube. It is designed for electrical joints, terminals and switch contacts in power generation, transmission, distribution and supply systems, reducing contact resistance and temperature rise while protecting copper, aluminium and steel surfaces against galvanic corrosion and rust in high-temperature, severe-cold and coastal chemically corrosive environments. Service range -40 °C to 180 °C.

Features and Benefits

FeatureBenefit
Low contact resistance and reduced temperature riseLowers resistance and temperature rise at conductor contact surfaces, cutting active power loss at bolted joints.
Excellent anti-galvanic corrosion and rust protectionProtects copper, aluminium and steel contact surfaces against galvanic corrosion and rust in humid, salt-fog and chemically corrosive environments.
Wide service range, -40 °C to 180 °CStays in place at high temperature without flowing out and does not crack or harden at low temperature.
Good oxidation and chemical stabilityResists oxidation and chemical attack, keeping the protective and conductive film effective over long service intervals.
Electrical joint application coverageFor bolted busbar joints, switch contacts, terminals and battery connections in power generation, transmission, distribution and supply systems.
Non-toxic, odourless and non-flammableComfortable and safe to apply by hand or with tools, and suitable for general transport.

Typical Data

ParameterValueTest method
NLGI grade2Q/SY RH2159
Product classificationISO 6743-9 (GB 7631.8-90)-
Product standardQ/SY RH2159-
Operating temperature range (°C)-40 to 180Q/SY RH2159
Base oil / thickener typeNot published in the reviewed KunLun sources; refer to the current PDS-
Worked penetration (0.1 mm)Not published in the reviewed KunLun sources; refer to the current PDS or batch certificate-
Dropping point (°C)Not published in the reviewed KunLun sources; refer to the current PDS-
Electrical behaviourConductive contact grease for electrical joints; measured contact-resistance values are not published in the reviewed sources-
Packaging100 g tube (0.8 kg can, 15 kg drum, 175 kg drum and bulk packing also available)-

Packaging and Storage

  • Packed in 100 g tubes; 0.8 kg cans, 15 kg drums, 175 kg drums and bulk packing are also available on request.
  • Store in a cool, dry and well-ventilated place with the container tightly closed.
  • Keep away from open flame, heat sources and strong oxidising agents.
  • Use clean, dedicated tools and containers; keep the grease free of water, dust and metal particles.
  • Reseal the tube after use and do not mix with other types of grease.

Notes

  • Clean the contact surfaces and remove oil, dust and oxide before application; apply a thin, even film and wipe off excess after bolting.
  • Do not mix with other types of grease.
  • Avoid prolonged or repeated skin contact; wear oil-resistant gloves and safety goggles.
  • Keep away from ignition sources; do not cut, weld or heat empty containers.
  • Dispose of empty packaging and used grease through licensed recyclers.

Health and Safety

  • Avoid contact with eyes and skin. In case of contact, wash thoroughly with plenty of water and soap.
  • Do not ingest. If swallowed, do not induce vomiting and seek medical advice immediately.
  • Use with adequate ventilation when working inside enclosed switchgear or battery compartments.
  • Collect used grease and empty packaging for authorised recycling; never discharge into drains, soil or water.
  • Refer to the product safety data sheet (SDS) for full handling information.

Leave Your Message